Retention of 3-D-Printed, Milled, and Conventionally Fabricated Occlusal Splints

Khalil Ibrahim Assiri; Nasser M. Alqahtani; Mohamed Khaled Addas; Mohammad Zarbah; Ali Mosfer Alqahtani; Faisal Awad Aziz Alamri; Mudita Chaturvedi; Saurabh Chaturvedi

doi:10.12659/MSM.947342

21 April 2025 : Laboratory Research

Retention of 3-D-Printed, Milled, and Conventionally Fabricated Occlusal Splints

Khalil Ibrahim Assiri^1ABCDEFG, Nasser M. Alqahtani^2ACDEFG, Mohamed Khaled Addas^2ABCDEFG, Mohammad Zarbah^2ADFG, Ali Mosfer Alqahtani^1ADFG, Faisal Awad Aziz Alamri^3ADFG, Mudita Chaturvedi^4ADEF, Saurabh Chaturvedi^2ABCDEFG*

DOI: 10.12659/MSM.947342

Med Sci Monit 2025; 31:e947342

Authors information Article notes Copyright and License information

Introduction Material and Methods Results Discussion Conclusions References

Related articles Order reprints Share article Share by email

View HTML version

Figure 3 Representative images of steps for fabrication of occlusal splints: (A) scanned maxillary and mandibular cast; (B) occlusal view of maxillary cast with path of insertion; (C) blocked out maxillary cast.

Back to the Article

Retention of 3-D-Printed, Milled, and Conventionally Fabricated Occlusal Splints

Your Privacy